Controlling Electric Locks with Calendars

This section describes how to connect an electronic lock, magnet lock or strike plate to enable its control with a calendar.

Proceed as follows.

  1. Make sure that the switch on Net Bridge is set to STANDBY.
  2. Connect the Door Module to the prepared Net Bridge, or continue the bus from the last device on the main bus in accordance with the wiring diagram in iLOQ Online - Design Guide.
    Note:

    If you are continuing the bus from another bus device, remember to remove the bus termination (TERMINATION = OFF) from the device from which you are continuing the bus.

  3. Connect the electronic lock control to the K1 or K2 relay output in accordance with the lock manufacturer’s instructions.
    Note:

    Do not use the bus voltage (DC+, DC-) as the electronic lock's power source.

  4. Set Operation Mode 2 by using the OPTIONS switches as follows:
    S1 ON
    S2 ON
    S3 OFF
    S4 OFF
  5. Set TERMINATION (TE/TEST) to ON if this bus device is the last device in this bus branch. If not, set it to OFF.
  6. After connecting the remaining bus devices, complete the Net Bridge settings once (see Completing the Bus Device Configuration on Net Bridge) and continue this procedure.
  7. In iLOQ 5 Series Manager, check that the connected Door Module has been added to the Net Bridge device list. You can identify the Door Module by its serial number.
  8. Set the connected relay as a calendar controlled door. See Adding Calendar Controlled Doors
  9. If you don’t already have a suitable calendar for the door, add a calendar. See Adding Control Calendars for Doors.
  10. If you don’t already have a suitable calendar with control, add control to the calendar. See Adding Direct Controls to Calendars.
  11. Connect the calendar to the door. See Connecting Calendars to Calendar Controlled Doors.