iLOQ Online System and Devices
Installation and usage instructions for the iLOQ Online system and various iLOQ devices
- iLOQ Online System
- Bus Addresses and Bus Termination
- Deploying the iLOQ Online System Hardware
  - Preparing N500 Net Bridges
    This section describes how to prepare a Net Bridge for deployment.
  - Preparing N500 Net Bridge and Connected Bus Devices for Deployment
    This section describes how to prepare the N500 Net Bridge and connected bus devices for deployment.
  - Programming Net Bridge for Deployment and Completing a Device Configuration
    This chapter describes how to complete the device configuration of a Net Bridge.
  - Defining inputs and outputs for N507 Net Bridge
    This section describes how to define inputs and outputs for an N507 Net Bridge in iLOQ 5 Series Manager.
  - Preparing N501 4G Door Modules
    This chapter describes how to prepare a 4G Door Module for deployment.
  - Editing Door Module Relay Settings
    This section describes how to edit door module relay settings.
  - Quick Guides
    - Connecting Key programming Hot Spots
      This section describes how to connect a Key programming Hot Spot.
    - Connecting Remotely Controlled Lock Cylinders
      This section describes how to connect a lock cylinder to enable remote control.
    - Controlling Electric Locks with Calendars
      This section describes how to connect an electronic lock, magnet lock or strike plate to enable its control with a calendar.
    - Controlling Electronic Locks with Code Access Groups
      This section describes how to connect an electronic lock, magnet lock or strike plate to enable its control with a code access group.
    - Controlling Electronic Locks with RFID Readers
      This section describes how to connect an electronic lock, magnet lock or strike plate to enable its control with an RFID reader.
    - Controlling Alarm Systems with RFID Readers
      This section describes how to use an RFID reader to control an alarm system.
    - Controlling Electronic Locks with RFID Keys and PIN Codes
      This section describes how to connect an electronic lock, magnet lock or strike plate to enable its control with an RFID key and PIN code. The presented connection uses a keyboard equipped RFID reader and a key with an RFID chip.
    - Controlling Electric Locks by a Combination of an RFID Key and a PIN-code
      This section describes how to connect an electric lock, magnet lock or electric strike plate, and so on, to be controlled by a combination of an RFID key and a PIN-code. In this connection, you use an RFID reader equipped with a keypad and a key equipped with an RFID chip.
    - Connecting Monitored Doors
      This section describes how to connect monitored doors.
  - Completing the Bus Device Configuration on Net Bridge
    This section describes how to finalize the bus device configuration on the Net Bridge.
  - Operation Modes
- Software and Firmware Updates
- Troubleshooting
- Programming Keys
- Recycling of Decommissioned Products

Quick Guides

This chapter presents the most common use cases and configurations of the iLOQ Online system.