Connecting Remotely Controlled Lock Cylinders

This section describes how to connect a lock cylinder to enable remote control.

Proceed as follows.

  1. Make sure that the switch on Net Bridge is set to STANDBY.
  2. Connect the Door Module to the prepared Net Bridge, or continue the bus from the last device on the main bus in accordance with the wiring diagram in iLOQ Online - Design Guide.
    Note:

    If you are continuing the bus from another bus device, remember to remove the bus termination (TERMINATION = OFF) from the device from which you are continuing the bus.

  3. Connect a programmed lock cylinder to the Door Module's CYLINDERS L1 or L2 connector in accordance with the connection instructions.
  4. Set Operation Mode 1 by using the OPTIONS switches as follows:
    S1 ON
    S2 ON
    S3 OFF
    S4 OFF
  5. Set TERMINATION (TE/TEST) to ON if this bus device is the last device in this bus branch. If not, set it to OFF.
  6. After connecting the remaining bus devices, complete the Net Bridge settings once (see Completing the Bus Device Configuration on Net Bridge) and continue this procedure.
  7. In iLOQ 5 Series Manager, check that the lock no longer has an orange background colour in the lock grid view. Remember to refresh the grid view by pressing the F5 key.