Viewing Calendar Controlled Door Properties
This section describes how to view the properties of a calendar controlled door on iLOQ 5 Series Manager.
Proceed as follows.
- Select .
-
Right-click the selected door and select
Properties.
The tabs are:
-
Basic information — The fields are:
-
Network module name — This field indicates the network module name to which the Door Module is connected.
-
Door name — The name of the calendar controlled door.
-
Relay number — The number of the output relay, which this calendar controlled door controls.
-
Door module serial number — The serial number of the Door Module.
-
The following information refers to lock information, if the door module is programmed as a lock, and it controls the same relay as the calendar.
-
Placement — This column contains the placement information of the lock.
-
Locking target — This column contains the locking target information of the lock.
-
Lock serial number — The serial number of the lock, that is, the Door Module.
-
-
Relay type — This value is always Relay.
-
-
Calendars — This tab contains the calendars attached to control the door. The columns are:
-
Calendar name — The names of the calendars attached to control the door.
-
Description — The descriptions of the calendars attached to control the door.
-
Type — This tab contains the calendar type. See Calendar Controlled Doors.
-
Estate — This tab contains the estate of the calendar.
-
Zone — This tab contains the zone of the calendar.
-
-
Lock — This tab contains lock information, if the door module is programmed as a lock. See Browsing Locks.
-
Door audit trail — This tab contains the event log on the calendar controlled door relay. The columns are:
-
Index — The consecutive event number. The possible lock event index numbers refer to the lock audit trail event numbers.
-
Point of time — The time when the event took place.
-
Event type — The type of event.
-
Duration — Duration of the calendar control.
-
Source — The controlling source, such as a calendar name or lock placement.
-
-