Browsing Calendar Controlled Doors
This section describes how to browse calendar controlled doors on iLOQ 5 Series Manager.
You can monitor the physical status of a monitored door.
Proceed as follows.
The columns are:
-
Door name — The calendar controlled door name.
-
Placement — Placement refers to the location of the lock on the floor plan. If you are adding several locks at a time, set the first placement in a way that it ends with a number, such as A1. In this way, the system adds consecutive placement numbers as follows:
- A1
- A2
- A3
- ...
-
Locking target — Locking target provides a more detailed description or name of the room or premises, where the lock will lead to.
If you are adding several locks at a time, set the first locking target in a way that it ends with a number, such as Door 1. In this way, the system adds consecutive locking targets as follows:
- Door 1
- Door 2
- Door 3
- ...
- Serial number — Serial number indicates the serial number of the lock. If a lock has a serial number in the software, it also has a physical counterpart. This information is only shown for locks that have been programmed in the system.
-
Latest state — The latest state of the calendar controlled.
-
State updated — The time when the calendar controlled door state was last changed.