Operation Mode 9

This operation mode is intended for connecting one or two networked lock cylinders, and a reader, if necessary, which control relay output K1.

An example use case is an alarmed door, or a door where a magnet lock is bypassed by a valid key insertion to the lock cylinder.

Opening the cylinder activates relay output K1 that bypasses the door magnet contact, or opens the magnet lock, for 3 seconds by default. This period can be changed through iLOQ 5 Series Manager.

In this case:

• The Door Module is programmed.

• Relay output K1 cannot be calendar-controlled. The idea is to prevent bypassing an alarmed door from iLOQ 5 Series Manager.

The table below describes the inputs controlling outputs K1 and K2 and whether the outputs are calendar-controllable, and if door status can be connected to the input.

You can connect any potential-free contact information, such as a magnetic door contact, to IN2. In this way, you can request for the door status information through iLOQ 5 Series Manager and view the event log on the door status. If you have to obtain status information from, for example, both the lock strike plate and the door, you can serial connect the lock and door contacts. In this case, the status indicates whether the door is closed and locked, or not.

You can deploy this installation by applying the instructions in Controlling Electronic Locks with RFID Readers, even if you are not planning to connect the reader. However, set the OPTIONS dip switches as follows: