This section describes how to identify locks on iLOQ Manager.
You may want to identify a lock, if you do not know if the lock is part of the system
or not, and to find out the placement of the lock in the system
Proceed as follows.
-
Select .
-
Enable Programming state.
-
Insert the lock programming cable into the lock that you want to
identify.
-
If the lock belongs to this iLOQ Locking System, the system displays the lock
placement number, and programs the lock, if a programming task has been ordered
for it.
If:
-
The lock belongs to another iLOQ Locking System, the system displays
a message on this.
-
The lock is in the factory state, the system suggests to deploy it,
if the deployment of new locks is ordered. If you choose to
deploy the lock, keep the against the lock
during the entire procedure.
-
Remove the lock programming cable from the lock.