This section describes how to format and program new locks in iLOQ Manager.
Formatting and Programming New Locks in the Lock View
This section describes how to format and program new locks in
iLOQ Manager.
When a new lock cylinder is delivered from the factory, it is in the
factory state. Before it can be programmed, it must first be formatted. After this
procedure, the lock cylinder can be managed in the deployed locking system only.
The Adding formatting task to a master token wizard is
opened.
Select Add formatting task.
Select the token where you want to add the formatting task.
Select Next.
A summary screen is shown.
Select Ready.
Type in the locking system master
password.
Select OK.
The formatting task is added on the token.
A summary screen is shown.
Select Close.
Select Basic data > Browse locks.
Select the locks to be programmed.
The selected lock must be in the Ordered or Transferred to programming
state. If the lock is in the In planning
state, order the lock first. See Ordering Locks.
Right-click to select Program lock.
The Programming of locks wizard is opened.
Select Program locks.
A list of locks to be programmed is shown.
Select Next.
Select Program locks.
Select Next.
A summary screen is shown.
Select Ready.
A status screen is shown, displaying the lock that is next in the programming
queue.
Insert the programming cable to the requested lock.
Follow the instructions on the programming status screen.
A summary screen is shown.
Select Close.
The programmed locks appear in the lock grid view in the Programmed
state.
Remove the formatting task from the token by clicking the Format state again, and follow
the wizard to empty the token.