Editing Key Switch Relay Settings

This section describes how to edit Key switch relay settings on iLOQ Manager.

Proceed as follows.

Select Basic data > Browse locks.
Right-click the Key switch to select Edit key switch relay settings.

The Editing of key switch relay settings wizard is opened.
Select Edit Key Switch relay settings.
Select Next.
Select the relay configuration from the Select relay configuration and type relay data drop down menu.

For more information, see Relay Configurations.
Select the relay mode in the <Select relay mode> drop down menu.

See Relay Modes.
Select Next.
Select how to proceed.
The options are:
- Leave locks in planning state — Select Leave locks in planning state if you want to leave the locks in the planning state, and program the locks later.
- Order locks — Select Order locks if you want to create the programming task, but execute it later, or program networked locks.
- Order and program locks — Select Order and program locks if you want to create the programming task, and execute it at once for a single lock at hand.
- Order and transfer tasks to programmer — Select Order and transfer tasks to programmer if you want to create the programming tasks, transfer them to the Programmer, and take the Programmer with you to program the locks at the site. If you have networked locks, this option will also program them through the network.
Select Next.
Select Ready.
Select Close.