Time Zone

This section describes how to change the time zone of the locking system, and use multiple time zones on iLOQ 5 Series Manager.

Normally, the time zone is pre-set by iLOQ to the correct value in iLOQ Locking System. The set time zone depends on the country where the system is delivered to. If the system is used in a different country as the delivery country, you may need to change the time zone.

Note:

Multiple time zones can only be taken in use with S50 locking systems.

Important:

If the system contains keys that have time limits, you must re-program the keys after you have changed the time zone. Otherwise, the keys will be valid at incorrect times.

Proceed as follows.

  1. Select Administration > Edit locking system information.

  2. Select Time zone in the Views area.
  3. If necessary, select the correct time zone in the Time zone drop-down menu.
  4. If you want to use multiple time zones select the In use check box in the Multiple time zones in the locking system area.

    The time zone will then be selected for each system zone separately. The time zone selected in the Time zone setting will be used as the default time zone.

  5. Select Save and close.