Sending Requests to the Network Module
This section describes how to send requests to a network module in iLOQ 5 Series Manager.
The following requests can be sent to the network module:
- Audit trail pick request that reads the logs of the locks connected to the module
- Programming request for locks connected to the module
- Calendar fetch request that sends calendar updates to the door modules
- Reboot request that deploys the device reboot
- Firmware update request that deploys the manual firmware update to the devices
- Setup request that deploys the device setup to re-address the bus devices
- Status request that enables user to fetch Net Bridge status
- Request to test connection.
-
Select
.
- Choose the desired network module.
- Right-click the selected module and choose Send to network module.
-
Choose the request to send to the network module.
Depending on the communication settings (not the license type), sent requests are either queued or executed immediately.