Resetting Locks to Factory State

This section describes how to reset locks to factory state.

1. Select Basic data > Browse locks.

   

2. Select the locks you want to reset.
3. Right-click the selected lock and select Reset lock.
   The Reset a lock wizard is opened.
4. Select Reset locks.
5. Check that the correct lock is selected.
6. Select Next.
7. Select how to proceed:

   • Leave locks in planning state — Select Leave locks in planning state if you want to leave the locks in the planning state, and reset the locks later.

   • Order locks — Select Order locks if you want to create the programming task, but execute it later.

   • Order and program locks — Select Order and program locks if you want to create the programming task, and execute it at once for a single lock at hand.

8. Select Next.
9. A summary screen is shown.
10. Select Ready.
11. Select Close.

    The physical lock is now in the Factory state. The lock definition on iLOQ Manager has remained in the In planning state. If you want to proceed to deleting the lock row from iLOQ Manager, see Deleting Locks .