This section describes how to block a key on iLOQ Manager.
This function is used to prevent a lost key from accessing the locks. The lock
re-programming must be carried out by using the Programmer, or through the network.
An alternative way to blacklist a key is to blacklist it by a replacement key. For
more information, see sections Creating a New Replacement Key and Converting an Existing Key to a Replacement Key.
Proceed as follows.
-
Select .
-
Select Add to blacklist.
The Add to blacklist wizard is opened.
-
Select Add a key to the blacklist.
-
Select the key that you want to add to the blacklist.
-
Select Next.
-
Select how to proceed with the locks affected.
The options are:
-
Leave locks in planning state — Select
Leave locks in planning state if you
want to leave the locks in the planning state, and program the locks
later.
-
Order locks — Select Order
locks if you want to create the programming
task, but execute it later, or program networked locks.
-
Order and program locks — Select
Order and program locks if you want
to create the programming task, and execute it at once for a single
lock at hand.
-
Order and transfer tasks to programmer —
Select Order and transfer tasks to
programmer if you want to create the programming
tasks, transfer them to the Programmer,
and take the Programmer with you to
program the locks at the site. If you have networked locks, this
option will also program them through the network.
-
Select Next.
-
A summary screen is shown.
-
Follow the wizard to end the
procedure.