This section describes how to create replacement keys on iLOQ Manager.
This function is used to set a lost key to the blacklist by using a replacement key,
instead of using the Programmer. The replacing key will
inherit the access right(s), person attachment, and so on, from the lost key.
Note:
Mandatory fields are marked with an asterisk (*).
Proceed as follows.
-
Select .
-
Select the lost key that must be replaced with a new key.
-
Right-click the key to select Create replacement key.
The Replace key wizard is opened.
-
Select Create new replacement key.
-
The selected key is shown in the key list.
-
Select Next.
-
If necessary, rename the key in the The name / description of the
key field.
-
Enter the planned return date in the Planned return date field.
-
Select Next.
-
Select how to proceed.
The options are:
-
Leave key in planning state — Select Leave keys in
planning state if you want to leave the key in the planning state, and
continue planning the locking system without, for example, programming any physical keys.
-
Order key — Keys must be ordered, before they can be programmed.
Ordering creates a programming task for the key, for later programming. For more
information, see Keys and
Ordering Keys.
-
Order and program key — Select Order and program
key to order a programming task, and to program the key at once. For more
information, see Programming Keys.
-
Order, program and hand over key — Select Order,
program and hand over key to order a programming task, and to program the
key, and to hand over the key to a person, at once.
-
Select Next.
-
Select whether you want to order the lock programming tasks or transfer them to
the Programmer for later programming.
-
Select Next.
-
A summary screen is shown.
-
Follow the wizard to end the
procedure.
-
Use the replacing key in the locks to block the lost key.
