Replacing Floor Plans

This section describes how to replace imported floor plans to iLOQ 5 Series Manager.

If your floor plan changes due to, for example, renovation, you can replace the existing floor plan with a new one, without losing the lock placements.

Note:

Required fields are marked with an asterisk (*).

Proceed as follows.

  1. Select Basic data > Floor plans.
  2. Select Add floor plan.
    The Importing of Floorplan wizard is opened.
  3. Select Replace floor plan.
  4. Select the file that contains the new floor plan.
  5. Click Next.
  6. Select the floor plan that will be replaced.
  7. Click Next.
  8. Enter a name and a description for the floor plan or use the pre-filled name.
  9. Click Ready.
  10. The figure is uploaded on the server.
  11. Check that the figure is sharp enough.
    If the figure is not sharp enough, replace the figure again.
  12. If the replacing floor plan is of a different size than the original, and the locks are on incorrect locations, you can move the locks in their correct positions all at once. See Dealing with Re-scaled Floor Plans.