This section describes how to edit the access right lock selections on iLOQ Manager.
-
Select .
-
Right-click the access right that you want to edit, and select Add / remove lock.
The Edit access right wizard is opened.
-
Select Edit access right selections.
-
Edit the lock selections of the access right.
-
— Click the Arrows
right button to move all items to the selection list.
-
— Click the Arrow
right button to move the selected item(s) to the selection list.
-
— Click the Arrow
left button to remove the selected item(s) from the selection list.
-
— Click the Arrows
left button to remove all items from the selection list.
-
Select Next.
-
If you are:
-
Deploying new locks, the options are:
-
Leave locks in planning state — Select Leave locks
in planning state if you want to leave the lock in the planning
state, and continue planning the locking system without, for example, programming any
physical locks.
-
Order locks — Select Order locks if
you know that the lock definitions are final, but you want to program the lock later.
For more information, see Ordering Locks.
-
Order and program locks — Select
Order and program
locks:
- If you know that the lock definitions are final, and you want to program the
lock at once.
- For locks that have not yet been installed on the premises.
For more information, see Programming Locks.
-
Order and transfer tasks to programmer — Select
Order and transfer tasks to programmer if you are
deploying a mounted lock, and you want to program it by disconnecting the Programmer
from the computer, and taking it to the lock to be deployed. You can only do this for
one lock at a time.
Note:
In this case, you will have two tasks for the lock: a formatting task on the token
and a programming task on the Programmer. Insert the programming cable to the lock,
wait for the green status light, and repeat once to get both tasks carried out.
-
Reprogramming deployed locks, the options are:
-
Leave locks in planning state — Select
Leave locks in planning state if you
want to leave the locks in the planning state, and program the locks
later.
-
Order locks — Select Order
locks if you want to create the programming
task, but execute it later, or program networked locks.
-
Order and program locks — Select
Order and program locks if you want
to create the programming task, and execute it at once for a single
lock at hand.
-
Order and transfer tasks to programmer —
Select Order and transfer tasks to
programmer if you want to create the programming
tasks, transfer them to the Programmer,
and take the Programmer with you to
program the locks at the site. If you have networked locks, this
option will also program them through the network.
-
Select Next.
-
A summary screen is shown.
-
Follow the wizard to end the
procedure.
