This section describes how to import lock data from Excel to iLOQ Locking System.
You can import the same data as you would enter through the Add
lock wizard. You cannot import any data related to the
lock state.
Proceed as follows.
-
Select .
-
Open the Excel sheet where the data to be imported is.
-
Arrange the Excel columns to match the columns in the lock grid.
You must import at least the columns below:
- Placement
- Locking target
- Lock cylinder type
The other columns are optional. You can also use empty columns on the Excel
sheet, if you want to skip importing some columns in the lock grid. Do not
import any column headings from Excel.
-
In iLOQ Manager, select Editing mode to enable editing
mode.
-
Copy the cells from the Excel sheet.
-
Select the empty row below the lowest data row.
Important:
Select the entire row by clicking the star icon on the
left-hand side of the row. Do not select the first cell on the row.
-
Paste the data.
-
Select Editing mode again to disable
editing mode.
-
Select Yes.