This section describes how to add control for the relays, on iLOQ Manager.
Adding relay controls as described below, requires that the relay has been set as a
calendar controlled door (see Adding Calendar Controlled Doors), and that it has
at least one calendar attached (see Attaching Calendars to Calendar Controlled Doors).
The network module has two relays that are controlled by calendar functions. You can
create single, one-time controls, or control sequences that are repeated according
to a calendar rule. Control sequences can allow for public holiday exceptions.
Proceed as follows.
-
Select .
-
Select the desired network module.
-
Right-click the selected network module and select Modify
controls.
A calendar view is opened.
-
Select the date for the control in the monthly calendar on the left-hand side
of the screen.
-
Select the time for the control in the relay-specific column on the right-hand
side of the screen. You can select the time by painting it with your
mouse.
-
Right-click the painted area and select Add
control.
Add control information as follows:
-
Target — Select the relay that you want to
control, in this drop-down menu. In other words, select either
Control Relay 1 and Control Relay 2.
-
Description — Enter a description for the
control, in this field.
-
Control begins — Enter a start time for the
control, in this field.
-
Control ends — Enter an end time for the
control, in this field.
-
Create control sequence — If you select this
check box, you can create a repeated control sequence. Add control
sequence information as follows:
-
Repeat control — Select how often the
relay sequence will be repeated, in this drop-down menu. The
options are:
-
Every week — If you select
Every week, the control
will be repeated every week on the defined time. Use the
weekday check boxes to select the weekdays on which the
control will be repeated. Define also the control
sequence ending criteria.
-
Every month — If you select
Every month, the control
will be repeated once every month on the defined date
and time. For example, if you have selected 10 May
06:00 as the First control
starts value and 10 May 22:00 as
the First control ends value, the
control will be applied on every tenth day of the month,
between 06:00 and 22:00.
-
Every year — If you select
Every year, the control
will be repeated once every year on the defined date and
time. For example, if you have selected 10 May
06:00 as the First control
starts value and 10 May 22:00 as
the First control ends value, the
control will be applied on every 10 May every year,
between 06:00 and 22:00.
By default, the control sequence will run indefinitely. If you want
to define an end date for the sequence, select the End
date in the Control sequence
ends drop-down list, and define the end date in the
date field.
-
Select OK.
-
Select Save.
-
A confirmation screen is shown.
-
Select OK.
-
Depending on the communication settings, not on the license type, the sent
requests are queued, or they will be immediately executed.
