1x2

With the Relay card, you can control one or two devices through the relay outputs K1 and K2.

The available relay modes are:

  • Toggle
  • Impulse
  • Key hold
  • Roller door

In this configuration, it is possible to specify the relay outputs that a particular access right has the right to control. A valid key can, therefore, activate either both or only one of the relay outputs K1/K2.

In the impulse relay mode, the impulse length is reset, if a valid key is read in the Key reader again, even if the previous impulse is still active. In other words, the calculation of the delay starts from the beginning.

Note:

You cannot use button inputs BUTTON1 / BUTTON2 in this configuration.

See also Appendix 2 - Wiring Diagram for R10S.3 1x2.