Lock Cylinder

You can control relay K2 with a lock cylinder connected to the Cylinder interface of the Relay card. Relay K2 is activated when a valid key is successfully read in the cylinder. A cylinder can only be connected in the Basic configuration and in the Impulse relay mode. You do not have to program the Relay card; relay K2 indicates a valid opening also in the factory state and in the formatted state.

The connected cylinder can be an S10 or Privus. An S10 cylinder does not need to be programmed in the same S10 system as the Relay card.

The default impulse of the K2 relay is 30 seconds, and it can be changed on iLOQ Manager, but this requires the programming of the Relay card. If the Relay card is equipped with the Real-time clock A00.9, and is formatted or programmed, the cylinder receives the time from the Relay card.

See also Appendix 7 - Wiring Diagram for R10S.3 Cylinder.