Relay Card Interfaces
This section describes the Relay card interfaces.
Interface | Connector | Description |
---|---|---|
REAL TIME CLOCK |
A place for the real-time clock A00.9. The circuit board must be used unpowered, and it must be programmed after the installation of the clock. |
|
CYLINDER/ BUTTON2 |
GND |
An input for a lock cylinder or a potential-free point signal (for example, an opening button). The button activation controls relay K2 in the Roller door mode. When the cylinder is connected, a valid opening activates relay K2. A cylinder can be used in the Basic configuration and in the Impulse relay mode. Connected to the yellow-black bus on the cylinder.
|
I0 | ||
MODE SELECT |
1 | Use the dip switches to select the relay mode, that is, the behaviour of the relay outputs described in the Relay Mode Dip Switches table. Dips 1-3 can also be programmed, in which case the dip positions on the Relay card are overwritten. Dip 4, however, must always be in the correct position on the Relay card. |
2 | ||
3 | ||
4 | ||
BUTTON1 |
GND |
An input connector for a potential-free point signal (for example, button 1). The button activation controls relay K1 in the Roller door mode, when a valid key is in the Key reader. In the Toggle, Impulse and Key hold modes, relay K1 is controlled in line with the selected relay mode. |
INPUT |
||
GND |
Input connector for potential-free point signal. The input can be used to control a conditional access right. Open = Access right blocked. Closed = Access right permitted. |
|
EXT IN | ||
NET BOX | GND | A connector for connecting to a Door Module within the S10 Online
System. Connected to the cylinder interfaces.
|
DATA | ||
KEY READER |
GND |
Ground |
1-WIRE |
1-WIRE communication bus. Connected to the corresponding connectors on Key reader A10.56 or A10.42. A10.42: black=GND, red=1-WIRE. |
|
POWER ON |
A voltage output for controlling Key reader A10.56 ONLINE LED, when the Relay card is powered. |
|
STAT1 G |
A voltage output for controlling Key reader A10.56 green STAT1 G LED, when the key is approved. |
|
STAT1 R |
A voltage output for controlling Key reader A10.56 red STAT1 R LED, when the key is rejected. |
|
STAT2 G |
An output voltage 3.3 VDC, which follows the status of relay K1. Can be connected for controlling the A10.56 green STAT2 G LED, indicating the status of output K1. |
|
STAT2 R |
Not in use |
|
GND |
Ground | |
RELAY K2 |
NO |
The relay output K2 contacts. The output is controlled, depending on the relay configuration and the relay mode, with a key, opening button BUTTON1 or BUTTON2, and a lock cylinder. The output default impulse length is 30 seconds. |
NC |
||
COM |
||
RELAY K1 |
NO | The relay output K1 contacts. The output is controlled, depending on the relay configuration and the relay mode, with a key or opening button BUTTON1. The output default impulse length is 8 seconds. |
NC |
||
COM | ||
12…24VDC |
CENTER PIN DC+ |
A plug connection for the power supply. The plug dimensions are 2.1/5.5 mm. On centre pin +. Voltage 12 – 24 VDC |
12…48VDC |
GND |
A connector for the power supply. The operating voltage is 12 – 48 VDC. |
DC+ |