Controlling an Electric Lock by a Combination of a Key and a PIN-code

This section describes how to connect an electric lock, magnet lock or electric strike plate, and so on, to be controlled by a combination of a key and a PIN-code. In this connection, you use a Key Reader and a keypad (RFID reader equipped with a keypad).

In this scenario, you program the Door Module as a Key Switch, which has its own access rights. For this, you have to connect the power supply and a Key Reader to the Door Module, during the first programming.

Proceed as follows.

  1. Ensure that the Net Bridge switch is on STANDBY.
  2. Add, format and program the Door Module to the lock list as a Key Switch.

    Select the type of lock cylinder as N102.

    Select the type of lock as Networked.

  3. Connect Door Module to a prepared Net Bridge, or continue the bus from the last connected bus device, according to the connection diagram in iLOQ S10 Online System - Planning Guidelines.
    Note:

    If you continue the bus from another bus device, remember to disable the termination (TERMINATION = OFF) from the device from which you continue the bus.

  4. Connect the Key Reader to the Door Module READER RS-485 bus according to the connection diagram.

    Ensure that the TERMINATION dip switch on the Key Reader is OFF.

  5. Connect the RFID reader (with a keypad) to the Key Reader RS-485 OUT connector according to the connection diagram.
  6. Connect an electric lock control to the relay output K1, according to the electric lock manufacturer's instructions.
    Note:

    Do not use the bus power (DC+, DC-) for powering the electric lock.

  7. Set the operation mode 3 by the OPTIONS dip switches as follows:
    S1 ON
    S2 ON
    S3 OFF
    S4 OFF
    S5 OFF
  8. Set the TERMINATION (TERM) dip switch to the ON position, if this bus device will be the last device on this bus branch. Otherwise, set it OFF.
  9. When you have also connected the other bus devices, finalize the Net Bridge configuration once (see Finalizing the Bus Device Configuration on Net Bridge) and continue this procedure.
  10. On iLOQ Manager software, check that the orange background color for the lock has disappeared from the lock grid view. Remember to refresh the grid view by pressing F5.
  11. Add the key PIN-code calendar, unless you already have a suitable key PIN-code calendar for the lock. See Adding a Key PIN-code Calendar.
  12. Attach the key PIN-code calendar to the lock. See Attaching a Key PIN-code Calendar to Locks.