This section describes how to program locks on iLOQ 5 Series Manager.
Proceed as follows.
Select Basic data > Browse locks.
Select the locks to be programmed.
The selected lock must be in the Ordered or Transferred to programming state. If the lock is in the In planning state, order the lock first. See Ordering Locks.
Right-click to select Program lock.
The Programming of locks wizard is opened.
Select Program locks.
A list of locks to be programmed is shown.
Click Next.
Select Program locks.
Click Next.
A summary window is displayed.
Click Ready.
A status screen is shown, displaying the lock that is next in the programming queue.
Figure 1. Programming Status Screen
Either:
Insert the programming cable to the requested S5 lock.
Place the requested S50 lock against the Programming Adapter or Programming key.
Follow the instructions on the programming status screen.
A summary window is displayed.
Click Close.
The programmed locks appear in the lock grid view in the Programmed state.
